After cleaning with Alcohol wipes, use the dry wipe marked No 2. to wipe all the alcohol off. There is also a fine silky microfiber cloth available for dry cleaning.
Note: We don't suggest using the attached big soft Optishield microfiber cloth on this step - keep that one for day-to-day cleaning of your device :)

Make sure to remove any remaining dust parcticles on the screen - look at it from the side towards the light. You can use the attached dust removing sticker.

Take the screen protector and partly remove the protective foil marked Number 1.

For proper alignment, you can either choose to:

a) remove the protection from one corner and align in on one of the top corners on iPad, or

b) remove the whole protection from both top corners and align both of them, keeping the rest of the protection on.

If you stick the corners and you are not happy with alignment - don't worry, just gently peel them back off and re-apply.

When you are happy with how top corners are aligned, keep the protector straight and gently pull out the remaining protective foil, allowing the protector to stick to your device.

If you are not a superhero, you are going to see some air bubbles. Don't worry! This is normal.

Grab the attached squeegee card and gently pull out the bubbles starting in the center and pulling them out towards edges of your device. Be patient, this may take a minute or two.

Be sure to remove all the bigger bubbles. You may have trouble removing some small bubbles. If there is no dust trapped inside, don't worry! The material is designed in a way that they will disappear in the next 24 hrs!

When you removed all the big bubbles, remove the protection marked No 2 from the top of the protector. Congratulations, the installation is finished!